Booth Algorithm Based Squarer Design
2016-08-23
0 0 0
no vote
Other
Earn points
design an 8 bit signed number squarer. The squarer will receive the operand B, an 8-bit signed number. A rising edge on the
LOAD pin should latch the operand into internal register RA. The multiplier outputs the results on the Z port which is connected
to the internal 16 bit register. Each squaring step starts with a LOAD signal and ends with an END signal going high.
the design is based on the booth algorithm.
vhdl
Related Source Codes
EE247 Analysis and design of analog-to-digital int
0
0
no vote
Beiyou digital experiment parking lot
0
0
no vote
Clock frequency division design
0
0
no vote
FIR filter based on FPGA
0
0
no vote
Cameralink modulation and demodulation source code
0
0
no vote
No comment