LabVIEW serial communication
2016-08-23
0 0 0
4.0
Other
Earn points
LabVIEW serial code, suits the beginner to learn program, introducing: frame of main program consists of 3 components: program initialization, response program events, the program exits. Init: program initialization, main button OpenCom, serial, serial receive string, wave icons, controls such as count TX/RX, and reset to False or zero. Initialization status is only executed once, then a State Event. Event: program respond to events from an event structure, total responses 8 events: the Open/CloseCom button event; string number or baud rate changes; send button events; clear count button events; emptied to receive button events; emptying the waveform button events; save waveform button events menu selection event; exit button events. If this State, press the exit button, you go to the State Exit, otherwise the program will run in this State. Exit: exit. Exit, close any open handles to VISA requirements.
labview
通信
串口
Related Source Codes
Honeywell Leakage Sensor Testing System
0
0
no vote
VC port operation module
0
0
no vote
LMS algorithm
0
0
no vote
HTTP sever for labview
0
0
no vote
Zigbee for cc2530 serial communication
0
0
no vote
No comment