ZigBee Model
2016-08-23
0 0 0
no vote
Other
Earn points
ZigBee implementation is built on Matlab/Simulink using fundamental components in Simulink to demonstrate how reliably complex modulation schemes can be built, cost effectively and efficiently. The design of ZigBee transmitter using OQPSK modulation. Here we map input data bits to 8-chip PN sequences to be transmitted and results in a chip rate of two mega chips per second. After that, resultant chip sequence is send to the serial to parallel converter. It is used here to separate the odd and even bit indexed chips. Following this bipolar data formatting is performed and signal modulated with a 2.4 GHz carrier on the In Phase and QuadraturePhase data stream and adds it to get the required transmitter output signal.
matlab
zigbee
模型
Related Source Codes
GMSK Linear Receiver
0
0
no vote
NSGA-II algorithm
0
0
no vote
NSGA-III multi-objective optimization algorithm
0
0
no vote
Compressed sensing example
0
0
no vote
CFAR detector example
0
0
no vote
No comment