LFRTOPNG decoder
2016-08-23
1 0 0
4.0
Other
Earn points
INPUT:
*. LFR File : this file is where the RAW file is stored. This is a 10-bit file. These can be found directly off of the camera.
OUTPUT:
*. PNG File : complete 8 bit image directly from the sensor. I used the naive grbg demosaic (you may change this).
RUN:
Just run go in MATLAB. No special MATLAB functions needed except image processing toolbox, which you all should have.
The example input folder is in 'input/illum/'
*. LFR File : this file is where the RAW file is stored. This is a 10-bit file. These can be found directly off of the camera.
OUTPUT:
*. PNG File : complete 8 bit image directly from the sensor. I used the naive grbg demosaic (you may change this).
RUN:
Just run go in MATLAB. No special MATLAB functions needed except image processing toolbox, which you all should have.
The example input folder is in 'input/illum/'
matlab
解码器
LFRTOPNG
Related Source Codes
GMSK Linear Receiver
0
0
no vote
NSGA-II algorithm
0
0
no vote
NSGA-III multi-objective optimization algorithm
0
0
no vote
Compressed sensing example
0
0
no vote
CFAR detector example
0
0
no vote
No comment