The proficiency in MATLAB GUI CD program
2016-08-23
0 0 0
no vote
Other
Earn points
The basic instructions for using the folder program in Chapter 2-7 of master Matlab GUI CD program source code are as follows: 1. The folder is the MATLAB software m file program; 2. The program file is the electronic version of the matlab program of the example in each chapter, and the program name corresponds to the serial number of the example name; 3. The program in this folder has been debugged and has been used in MATLAB It can run normally in version 7.0 or above; 4. The main functions of the program are introduced in the program header. The basic instructions of the folder program in Chapter 8-14 are as follows: 1. The program in each chapter is saved separately; 2. The program name exmn (n represents the serial number), which represents the program code of the nth example in the corresponding chapter; 3. The program name GUI_ X_ M_ N is the program code of the nth example in Chapter M. 4. Other save names are consistent with books. When running, put the program code in the working directory of MATLAB, you can directly open the file to run the program (the original code is written in MATLAB 7). If the image file is used, it cannot be omitted, and it must be in a folder, otherwise an error will occur.
matlab
光盘
程序
Related Source Codes
GMSK Linear Receiver
0
0
no vote
NSGA-II algorithm
0
0
no vote
NSGA-III multi-objective optimization algorithm
0
0
no vote
Compressed sensing example
0
0
no vote
CFAR detector example
0
0
no vote
No comment