Binary to ASCII for LCD 16*2
2016-08-23
1 0 0
no vote
Other
Earn points
Host InterfaceThere were three registers, the instruction register, status register and the data register, visible through the host interface. Instructions RegisterWrite only 8-bit registers. When the instruction bytes when writing to this register, instruction decoder to follow the instructions. In the implementation process, will set the flag (BF). At different times, different instructions. RegisterRead only 8-bit registers. MSB indicated the blast furnace and the lower bit value representing the address counter. BF is indicates internal processes and the instruction register and the data register is not accessible. Before you can access these registers, make sure you blast clear. When access is not here to check registers, each access interval must be longer than the execution time of the time. Data RegisterRead/writing 8-bit registers. When when we write a byte, it wrote to CCRAM or ddram address counter indicates the location and then add counters to
verilog
ascii
显示器
液晶
二进制
Related Source Codes
AXI Host Slave Function Model
0
0
no vote
Axi slave to fifo code
0
0
no vote
DMA Controller Based on AHB
0
0
no vote
Verilog implementation of ldpc code
0
0
no vote
Minimum sum decoding
0
0
no vote
No comment