Realization of elevator double elevator
2018-06-22
0 0 0
no vote
Other
Earn points
Function Description: design a 6-floor (1 ~ 6) automatic double elevator control circuit, its functions are as follows: (details not considered can refer to the Tianhe building elevator operation law) / / each floor elevator entrance is equipped with 1 up and 1 down request switch, and the elevator is equipped with a stop request button for passengers to reach the level. (there is no down button on the first floor, and no up button on the sixth floor) / / there are elevator position indicating devices and elevator up and down status indicating devices. The elevator rises (falls) one floor per second. When arriving at a certain floor, the position of the elevator is indicated as that floor, and it remains until the elevator reaches a new floor. When the elevator arrives at the floor with stop request or the designated floor, the back door opens for 2 seconds, closes automatically after 5 seconds, and resumes after 2 seconds, and the elevator continues to run. It can remember all the request signals inside and outside the elevator, and respond in order according to the elevator operation rules. Each request signal is retained until it is removed after execution. Elevator operation rules: when the elevator is in ascending mode, it only responds to the ascending request of higher level than the elevator
Related Source Codes
Android AOA Android Open Accessory Development Usi
0
0
no vote
Golang AOA Android Open Accessory HID Control
0
0
no vote
PClite
0
0
no vote
GMSK Linear Receiver
0
0
no vote
The golden version of AFT that has been passed dow
0
0
no vote
No comment