Design of IIC interface driver based on FPGA
2017-04-02
0 0 0
no vote
Other
Earn points
FPGA is used to design an interface meeting IIC communication protocol, read and write the EEPROM on the development board, and use two external keys as the control end. When the "write control key" is pressed, FPGA writes a byte of data to the fixed address of EEPROM, and lights up an LED, indicating that the writing is successful. When "read control key" is pressed, FPGA reads data from EEPROM and displays the data to nixie tube.
Related Source Codes
Android AOA Android Open Accessory Development Usi
0
0
no vote
Golang AOA Android Open Accessory HID Control
0
0
no vote
PClite
0
0
no vote
GMSK Linear Receiver
0
0
no vote
The golden version of AFT that has been passed dow
0
0
no vote
No comment