for read and write EEPROM(flash bank ) in stm 32 f 407 tested for f407ig
At this stage the microcontroller clock setting is already configured,
this is done through SystemInit() function which is called from startup
1, I2C software simulation.
2, fast read/write EEPROM.
3, can be configured using any GPIO port pins for I2C communication.
4, support 9,554, EEPROM, DAC and other chip reads and writes.... EmbededC
INTERFACING 24LC64 EEPROM WITH AT89C51
EEPROM has i2c based interface and 8051 doesn't have any built in i2c modules,
so software i2c module is created in the code. This code is written in C
language using Keil uvision4 compiler.
It is a... EmbededC
It is I2c based interfacing of 24c04 EEPROM with pic 16f877a using xc8 compiler.
EAch function in the coding is named as its purpose of use.So this program is very easy to understand..:)
hope fully ....
Electrical SCHEMATIC Diagram for the STM32F103VE mini development board, with SD card , TFT, serial and USB interfaces.
You can use this SCHEMATIC as reference to make new project or to use this board.... ArmPDF
This Program allows an AVR with bootloader capabilities to Read/write its own Flash/EEPROM. To enter Programming mode the application is computed, and if bad, programming mode is entered. If not, normal execution is done from $0000 "reset" vector in Application area.... EmbededC
Nrf24le1 and Nrf24lu1P are modules available on ebay at a very low cost to build small sensor nodes.
Nrf24le1 programmer named nrfisp like this one (http://www.ebay.com/itm/NRF24lE1-NRF24LU1-NRF24LU1P-USB-Programmer-Adapter-with-Software-Video-Tutorial-/271164903768) does not have a Linu... EmbededPython