for read and write EEPROM(flash bank ) in stm 32 f 407 tested for f407ig
At this stage the microcontroller clock setting is already configured,
this is done through SystemInit() function which is called from startup
STM32F103 devices use the Cortex-M3 core, with a maximum CPU speed of 72 MHz. The portfolio covers from 16 Kbytes to 1 Mbyte of Flash with motor control peripherals, USB full-speed interface and CAN. ... AlgorithmC++
An Example Keil-MDK 4.xx Project based upon STM32F103VC (256MBYTE), HY35A TFT uses SSD1963 in a µCos-II / µCgui 3.90a environment.
I had implemented the SSD1963 Driver into the µCgui Environment so the demo is working nice and fast. Sometimes, it lacks due a fast access to the Display register a... ArmC
1, I2C software simulation.
2, fast read/write EEPROM.
3, can be configured using any GPIO port pins for I2C communication.
4, support 9,554, EEPROM, DAC and other chip reads and writes.... EmbededC
Frequency Range : 433/868/915MHz ISM bands
Sensitivity = –120 dBm
Output power range : +30 dBm Max (RFM23BP)
Low Power Consumption
550mA @ + 30dbm transmit
Data Rate = 0.123 to 256 kbps
FSK, GFSK,... EmbededC
The example code for STM32F103RC interface with SD Card, based on FATFS library.
You can see the software connection of MCU with SD Card via SPI interface.
With FATFS, you can make folfer, write and read file on SD Card very easy...... EmbededC
The example code for STM32F103RC with USB HID type.
You can see the software connection of MCU with USB in hardware config file.
This example allow you interface mcu stm32 with PC via USB HID. You can send data from stm32 to PC...... EmbededC