Upload Code
loading-left
loading loading loading
loading-right

Loading

Profile
No self-introduction
codes (2)
USB video capture program (software:LabVIEW)
4.0
provide simple uses of the webcam library are included in the zip file.
zuosi1314
2016-08-23
0
1
DYNAMOMETER SYSTEM TEST STEP (Ergometer system testing)
no vote
This setup consists of an Electric Dynamometer which applies a load to the Unit Under Test (engine).  The Electric Dyno is controlled using an analog output signal which is amplified by the Dyno Load Controller.  The Load Cell connected to the Electric Dyno is used to read the developed torque.  The Engine speed is controlled using an analog output - this output value is determined by the PID controller.  The Throttle Controller amplifies the PID output to run the Engine.  Thermocouples mounted on the engine read temperatures.  The Magnetic Pickup on the engine outputs a frequency which is converted to RPM. Signals are conditioned using SCXI modules before they are Acquired by the DAQ board in the PC. Before running this application, you must first create DAQmx Global Virtual Channels and scales that correlate raw sensor values such as volts to physical quantities such as temperature. For more specific information please refer to the hel
zuosi1314
2013-12-12
0
1
No more~