liquefaction analyse based on SPT-N
2016-08-23
0 0 0
no vote
Other
Earn points
Based on the blow count analysis program of standard penetration test, liquefaction test was carried out. It uses the İ Driss (1971) process to evaluate cyclic stress ratio calculations. At the end of the analysis, the liquefaction index for displaced persons was calculated. The format of the input data file is very simple. One example is floows:1.5231.5 15 18.44 39.02.5 21 18.44 38.53.5 26 18.44 19.54.5 26 18.44 19.55.5 34 18.44 29.56.5 29 18.44 20.57.5 28 19.12 8.508.5 30 19.12 3.909.5 30 19.12 3.7010.5 36 19.12 2.3011.5 30 19.12 1.3012.5 31 19.12 8.7013.5 32 19.12 3.5014.5 28 19.12 4.4015.5 24 19.12 7.3016.5 30 19.12 1.6017.5 19 19.12 0.7018.5 21 19.12 0.9019.5 21 19.12 0.8020.5 28 19.12 1.5023.5 17 19.12 3.4026.5 28 19.12 4.0029.5 37 19.12 8.50the value in the first row represents the depth of groundwater table from the surface 1.5. The value of the second line, 23, represents the data of the number, which is as follows. The first column represents the depth, the second column represents the standard penetration n value, the three columns represent the density and the last column represents the fine fraction.
matlab
分析
基于
标准
液化
Related Source Codes
GMSK Linear Receiver
0
0
no vote
NSGA-II algorithm
0
0
no vote
NSGA-III multi-objective optimization algorithm
0
0
no vote
Compressed sensing example
0
0
no vote
CFAR detector example
0
0
no vote
No comment