LED Blinking 8051
2016-08-23
1 0 0
no vote
Other
Earn points
In the above circuit diagram, AT89C52 is used to simulate the LED
blinking code. You can place AT89C51 here without any other change and
the code will still run the same. So, this example code can work on both
AT89C51 and AT89C52 micro-controllers.
A crystal of 11.0592 MHz is used here. You can use any crystal value from 3 to 24MHz with 8051. As we know that 8051 micro controller has an architecture which executes an instruction in 12 CPU cycles, hence this 11.0592Mhz crystal makes this 8051 run at 0.92 MIPS (Million of instructions per second). The code for this project is shown below.
A crystal of 11.0592 MHz is used here. You can use any crystal value from 3 to 24MHz with 8051. As we know that 8051 micro controller has an architecture which executes an instruction in 12 CPU cycles, hence this 11.0592Mhz crystal makes this 8051 run at 0.92 MIPS (Million of instructions per second). The code for this project is shown below.
c
Related Source Codes
PClite
0
0
no vote
generic embeded FTP Client
0
0
no vote
UDP Test Demo
0
0
no vote
TMS320F28335 DSP transmits data to EEPROM through
0
0
no vote
TMS320F28335 CAN communication source code
0
0
no vote
No comment